Skip to content

24/7 live answer

(817) 382-3840
Water Well Drilling Weatherford · TX

Permit & Code

What Are the Water Well Setback Requirements in Texas?

The distances a new well must keep from septic systems, property lines, pens and other wells, under state rules and the Upper Trinity district.

Written by , 24-year water well drillerUpdated

Under 16 TAC §76.100, a new Texas water well must sit at least 50 ft from a septic tank, 100 ft from a septic absorption field or spray area, and 150 ft from livestock pens, feedlots, privies and similar sources. Inside a groundwater district that regulates spacing, such as Upper Trinity in Parker County, the district's property-line and well-to-well distances apply instead of the state's 50-ft property-line rule.

Water Well Drilling Weatherford sites new wells across Parker County, and water well setback requirements in Texas come from two layers of rules: the state’s well construction standards, and the local groundwater district’s spacing. On a small lot, the combination decides whether a well fits at all.

State setbacks (16 TAC §76.100)

Keep the well at least…From
50 ftA septic tank or other watertight sewage/liquid-waste collection facility
100 ftA septic absorption field, spray area or dry-litter poultry facility
150 ftLivestock or poultry yards, feedlots, privies, cemeteries, pesticide mixing or loading facilities
50 ftAn adjacent property line, provided the other distances are met (not required inside a district that regulates spacing; see below)

The same rule sets how the well is finished at the surface. The casing must stand at least 12 inches above ground. A cement seal must run at least 10 ft down, and a concrete slab at least 4 inches thick must extend 2 ft out from the casing. Those are what stop surface water from running down the outside of the casing. A well on a site that floods needs a watertight sanitary seal and a steel sleeve reaching 36 inches above ground and 24 inches below it.

Can a driller shorten these distances?

Sometimes. Outside the Edwards Aquifer, the state rule lets the 100-ft and 150-ft contamination distances shrink to 50 ft if the well is cemented to 100 ft below the surface by positive displacement or tremie pressure filling, with an annular space 3 inches larger than the casing. That same grouting lets a well sit within 5 ft of the property line. Wells under 100 ft deep grout to the top of the production zone. The 50-ft septic-tank distance is not reduced by this option. The district’s own rules require the state standards to be met unless the Texas Department of Licensing and Regulation (TDLR) grants a written variance, and the owner or driller must send the district a copy (Rule 4.2(a)).

Which rule sets the property-line distance in Parker County?

The district’s. The state rule says a driller need not meet the 50-ft property-line distance when the well is in a groundwater conservation district whose rules regulate spacing, when the property’s own restrictions regulate well spacing and septic systems, or when public wastewater treatment serves the owner. Upper Trinity regulates spacing in Parker, Hood, Wise and Montague counties, so its table is the one to design to.

Upper Trinity district spacing by pump size

The district’s rules (PDF posted September 2026, Rule 4.3) set distances by the most water the well can actually produce as equipped:

Maximum production (as equipped)From other wellsFrom property line
8 gpm or less150 ft50 ft
More than 8 to 17.36 gpm300 ft100 ft
More than 17.36 to 30 gpm500 ft150 ft
More than 30 to 50 gpm1,000 ft250 ft
More than 50 to 80 gpm1,750 ft500 ft

Larger classes run up to 4,000 ft from other wells and 1,250 ft from the property line above 150 gpm. A typical household pump falls in one of the first two rows, so the pump you equip decides the distance.

The district’s minimum tract is 2 acres by default and 5 acres where the Trinity Aquifer is 60 ft thick or less or the tract lies west of that line (Rule 4.3(h)). The Wise County Messenger reported the new spacing taking effect January 1, 2027, and our Upper Trinity rules update tracks the timing. The rules PDF we read lists no start date for the table, so confirm with the district at 817-523-5200 before you finalize a site.

Three details in Rules 4.2 and 4.3 matter on a real lot:

  • Vertical offset. The well-to-well distance does not apply when the two wells’ completions are offset by 100 ft or more vertically, or the district finds an aquitard between them. The property-line distance and tract size still apply.
  • Contiguous tracts. If you own the groundwater rights under two touching tracts, the shared line does not count as a property line. A road or easement you don’t control still does.
  • Drill where you registered. The well must land within 10 ft of the coordinates on the registration, and the owner and driller share responsibility for that. A well in the wrong place can be ordered plugged.

In Tarrant County (including east Azle), the Northern Trinity Groundwater Conservation District sets its own spacing. Check with that district for wells on the Tarrant side.

Putting it on a site plan

Start with the septic design, because the drain field is usually the largest area to avoid. Draw a 100-ft circle around the drain field, 50 ft around the tank, and 150 ft around any pens or barns with animals. Then take the district’s property-line distance off every side and mark your neighbors’ wells with their spacing circles. Whatever space is left is where the well can go. On acreage the answer is usually easy. On 2–3-acre lots it can be tight, especially under the wider spacing. Our minimum acreage guide shows which lot sizes leave room, and the permit and registration steps cover the paperwork once the site works.

Lenders add their own check

FHA guidance calls for a well at least 10 ft from the property line, 50 ft from a septic tank and 100 ft from the drain field. That can drop to 75 ft where local authorities allow. When the well sits closer than 100 ft to a septic system, a water test is required. See buying a house with a well in Texas and how deep wells run in Parker County.

Bottom line

Draw every setback on your site plan before the septic or the house goes in: 50 ft from the tank, 100 ft from the drain field, 150 ft from pens, and the district's property-line and well spacing for the pump size you plan. Moving a drain field on paper is free; moving a well is not.

Questions about your own well? Call (817) 382-3840. A person answers 24/7.

Sources

  1. 16 Texas Administrative Code §76.100, well location and completion
  2. Upper Trinity GCD, District Rules (PDF posted September 2026), Rules 4.2–4.4
  3. Upper Trinity GCD, spacing chart
  4. Upper Trinity GCD, FAQs (spacing)
  5. Wise County Messenger, spacing rules effective January 1, 2027
  6. HUD Handbook 4000.1 (FHA single family housing policy)

Planning a well or facing a repair? Call a well tech now.

Open 24 hours, 7 days a week. Serving Weatherford & Parker County.

Quick answers

How far does a well have to be from a septic tank in Texas?

At least 50 ft from a watertight septic tank or other sewage collection facility, and at least 100 ft from the absorption field or spray area (16 TAC §76.100). A well grouted to 100 ft by the positive-displacement or tremie method can cut the 100-ft and 150-ft source distances to 50 ft.

How far from the property line?

State rules call for 50 ft, but a driller need not follow that rule inside a groundwater district whose rules regulate well spacing. The Upper Trinity district's table sets 50 ft for wells producing 8 gpm or less and 100 ft for wells producing more than 8 up to 17.36 gpm.

Does FHA have its own well distances?

Yes. HUD's FHA guidelines call for a well at least 10 ft from the property line, 50 ft from a septic tank and 100 ft from the drain field. That last distance can drop to 75 ft where local authorities allow. A water test is required when the well is closer than 100 ft to a septic system.

More residential well drilling guides

Residential Well Drilling service

Ask about your property

Share the address area and what you're planning. We'll call back with the nearby well depths and a price range.

Faster by phone, any hour: (817) 382-3840

We use your details only to call you back about this request. See our privacy notice.

(817) 382-3840 No water? A person answers 24/7