Skip to content

24/7 live answer

(817) 382-3840
Water Well Drilling Weatherford · TX
Technician lowering a water level meter into an open well casing to measure static water level on Parker County pasture

24/7 · Weatherford & Parker County

Water Well Service & Repair in Weatherford, TX

One call for everything between the aquifer and your faucet. We keep existing wells producing, fix what breaks, and tell you plainly when a part is near the end of its life.

(817) 382-3840 · Open 24 hours, 7 days a week

Call if you see

  • Loose, cracked or missing well cap
  • Water level or flow noticeably lower than last year
  • Cloudy or gritty water after rain
  • Well house flooding or wiring exposed
  • No record of when the well was last checked

Last updated

Water Well Drilling Weatherford provides water well service and repair for homes and ranches that already have a well: checking it, fixing it and keeping records on it. Most Parker County wells were drilled years ago by someone else and haven’t been looked at since. They usually keep working until something small, like a cracked cap or a waterlogged tank, turns into something expensive.

What a service visit covers

We start outside at the wellhead. Texas rules call for the casing to stand at least 12 inches above ground, a concrete slab at least 4 inches thick extending 2 feet out from the casing, and a cement seal at least 10 feet down. Those three details keep surface water, fertilizer and animal waste from running straight down the outside of the casing into the aquifer. Then we move to the equipment: switch, tank, gauge, amp draw and a timed flow test.

Why flow and water level matter here

Parker County wells draw from sands and limestone that respond to drought and to the neighbors’ pumping. State driller reports show the median new well near Weatherford finishing with water about 110 ft down. A reading taken on your own well today gives a baseline to compare against next summer. If the level has dropped close to the pump, it is far cheaper to lower the pump or add storage now than to replace a burned-out motor in August. See is my well going dry?.

Common repairs on older wells

  • Caps and vents. Older caps crack and let insects, rodents and runoff in. A sanitary cap is an inexpensive fix that matters most for bacteria.
  • Wiring in the well house. Heat, rodents and moisture damage connections. Loose wiring at the switch and control box is a common cause of intermittent outages.
  • Pressure tanks. A bladder tank that has lost its air charge makes the pump start every few seconds. See well pressure tank replacement.
  • Sand and sediment. Grit usually means the pump is set too close to the bottom, the screen has failed, or the well needs rehabilitation.

Keeping the paperwork straight

When you sell a property with a well, buyers and lenders ask about it. A dated service record, the State Well Report and a recent water test make that conversation easy. If the property changed hands, the Upper Trinity Groundwater Conservation District also asks the new owner to file a transfer of ownership form for the registered well.

Typical cost

$150–$400 for a service visit and system check

Repairs found during the visit are priced in writing before any work starts. Switch, control and wiring repairs usually add $150–$600.

Source: HomeGuide, well pump repair cost (2026)

What's included on every water well service & repair call

  • Wellhead inspection: cap, casing height, slab, conduit and vent
  • Pressure switch, gauge and tank pre-charge checked
  • Running amps and voltage compared with the pump's rating
  • Timed flow test at a hose bib to measure delivered gallons per minute
  • Static water level measured when the well can be opened
  • Visual check of water clarity and sediment at the first tap
  • Well house or pump shelter checked for drainage, heat and freeze exposure
  • Written condition report with recommended repairs and prices

Water Well Service & Repair: three ways it gets done

Comparison of neglect, patch-only and full service for an existing water well
Item Do it yourself Cheapest bid Done to standard
Well cap Missing or loose; insects and runoff get in Taped or wired shut Sanitary, vermin-proof cap with sealed wire entry
Knowing the well's output Unknown until it runs out Not measured Timed flow test and static level recorded each visit
Surface seal Soil washed away from casing Dirt piled back around casing Slab and grading checked so runoff drains away from the well
After opening the well Put back in service Put back in service Disinfected, as state rules require for drinking-water wells

How water well service & repair works, start to finish

  1. Book or call

    Routine checks are scheduled at your convenience; anything affecting water supply is handled as a service call, day or night.

  2. Inspect the wellhead

    Cap, casing, slab, wiring and vent are checked against state construction standards before we open anything.

  3. Test the system

    Pressure, amp draw, flow and, when useful, the water level. The readings go into your report so next year's check has a baseline.

  4. Repair and document

    Approved repairs are done on the spot where possible, the well is disinfected if opened, and you keep the written record.

Need water well service & repair in Weatherford or Parker County?

A person answers 24/7 and prices the job before work starts.

Water Well Service & Repair questions

How often should a water well be serviced?

Have the system checked once a year, at the same time as the annual bacteria, nitrate and total dissolved solids test that the Texas Well Owner Network recommends. A yearly visit catches a waterlogged tank or failing switch before it takes the pump with it.

How long does a water well last?

A properly cased and grouted well can serve for decades. The equipment wears out sooner: submersible pumps typically last 8 to 15 years and bladder pressure tanks about 10 to 15 years. Declining yield, sand in the water or a damaged casing are the signs the well itself needs attention.

Do you service wells drilled by other companies?

Yes. Most of our service work is on wells we didn't drill. The original State Well Report helps. If you don't have it, drillers have filed reports with the state since 2001, and we can often locate yours from the property location.

What does a water well service visit cost in Weatherford?

A service visit and system check typically runs $150 to $400, depending on distance and what needs testing. If we find a problem, you get the repair price in writing before any work is done.

Do you answer after hours and on weekends?

Yes. The phone is answered 24 hours a day, 7 days a week. After-hours work is priced before we roll, and if the fix can safely wait until morning we will tell you so.

Sources

Related well services

  • Well Pump Repair

    No water, low pressure or a pump that won't shut off. We trace the fault from breaker to pump before anything comes out of the hole.

  • Well Rehabilitation

    Cleaning, shock chlorination and redevelopment for wells losing yield to iron bacteria, scale or sand.

  • Water Well Inspection

    Pre-purchase well inspections for Parker County property: flow and pressure test, equipment condition, records check and a bacteria sample.

Request water well service & repair

Tell us what the well is doing and where it is. Not urgent? We'll call back first thing.

Faster by phone, any hour: (817) 382-3840

We use your details only to call you back about this request. See our privacy notice.

(817) 382-3840 No water? A person answers 24/7