Skip to content

24/7 live answer

(817) 382-3840
Water Well Drilling Weatherford · TX

Learn

How Deep Are Water Wells in Parker County?

Median depths and water levels for new household wells in every town we serve, from Texas Water Development Board driller reports.

Written by , 24-year water well drillerUpdated

New household wells in Parker County have a median depth of 240 ft, and the middle half fall between 200 and 300 ft, based on 4,746 Texas Water Development Board driller reports since January 2021. Water typically stands about 110 ft down. East-side wells run deeper, with Aledo's median at 320 ft, while Peaster, Poolville and Brock cluster at 215–220 ft.

Water Well Drilling Weatherford pulled every new household well report filed in Parker County and its neighbors to answer this properly. How deep are water wells in Parker County? depends on which part of the county, and the state’s own records make that easy to show.

Depth by town

New household wells within about five miles of each town (six for Weatherford, Granbury and Mineral Wells), January 2021 to September 2026:

AreaNew wellsMedian depthMiddle halfTypical water level
Parker County (all)4,746240 ft200–300 ft~110 ft
Weatherford590240 ft200–340 ft~110 ft
Aledo357320 ft252–360 ft~176 ft
Springtown178240 ft200–380 ft~100 ft
Azle324220 ft200–240 ft~80 ft
Peaster924220 ft200–240 ft~90 ft
Poolville685215 ft200–220 ft~80 ft
Brock600220 ft200–260 ft~125 ft
Millsap110200 ft160–240 fttoo few readings
Mineral Wells185200 ft200–260 ft~85 ft
Granbury (Hood Co.)157360 ft200–420 ft~260 ft
Hood County (all)642360 ft220–400 ft~240 ft

Is a 100-foot well deep enough in Parker County?

Rarely. Only 1.2% of the 4,746 new household wells reported in Parker County since January 2021 stopped at 100 ft or less, and 3.5% at 150 ft or less. Water stands about 110 ft down in a typical new well, so a 100-ft hole often wouldn’t leave room for the pump below the water. The shallow ones cluster on the west side, around Millsap, Lipan and Brock.

How finished depths spread across those 4,746 wells (our count of the state extract):

Finished depthShare of new household wells
100 ft or less1.2%
150 ft or less3.5%
200 ft or less37%
250 ft or less63%
300 ft or less76%
400 ft or less96%

So roughly 1 new well in 25 goes past 400 ft, mostly on the east side around Aledo, Azle and east Weatherford.

How deep is the pump set in a Parker County well?

The median pump setting is 200 ft, on the 74% of reports that recorded it, and the pump typically hangs about 40 ft above the bottom of the hole. Where a report gives both the pump setting and the static water level (1,718 wells), the median well has about 100 ft of water above the pump when it’s finished.

That margin matters. The Upper Trinity district’s Rule 4.4(d) asks new wells to be completed with at least 50 ft of groundwater over the pump, or to fully penetrate the aquifer layer with the pump at the lowest practical point. A typical new Parker County well clears that benchmark about twice over. If your own report shows much less water above the pump, read is my well going dry? before summer, and see what is a good GPM for a well for the flow side of the question.

Why depth changes across the county

Deeper wells go with deeper water: the static water level in these wells runs from a median of about 65 ft in wells under 200 ft to 280 ft in wells of 400 ft and deeper.

The Upper Trinity district’s management plan describes four Trinity aquifer layers under Parker County:

  • Paluxy Sand: fine sand; small to moderate yields.
  • Glen Rose Formation: mostly limestone; small, localized yields.
  • Twin Mountains Formation: coarser sand with a massive lower section; moderate to large yields. Wells are usually completed in its lower part.
  • Antlers Formation: where the Glen Rose thins out to the north (around central Wise County), the Paluxy and Twin Mountains merge into the Antlers.

In the east, younger Fredericksburg and Washita limestones overlie the Trinity. That’s why Aledo wells run deeper and water stands lower. In the far west, the Trinity is absent and wells tap the Cross Timbers Aquifer, older rock where water sits in fractures and sandstone lenses. There, depths are modest but yields vary, as around Millsap and Mineral Wells. Hood County wells often go to the deep Twin Mountains, and 41% of new wells around Granbury went 400 ft or deeper.

Are wells getting deeper?

In some places. Around Aledo, the median new well went from about 240 ft in 2011–2013 to 320–350 ft since 2018. Around Granbury, it rose from about 320 ft in 2006–2015 to 360–400 ft since. Around Weatherford, Azle, Peaster and Poolville, medians have barely moved in 20 years. The pace of drilling has slowed: Parker County new household well completions fell from 1,287 in 2022 to 649 in 2025.

Buying a place with an existing well? The checklist for buying a house with a well in Texas explains how to read its State Well Report against these numbers.

Depth and cost

Depth drives most of a new well’s price. Drilling and casing typically run $30–$45 per foot (how Texas per-foot rates compare by region), and deeper wells need the pump set lower too, which is why a submersible, not a jet pump, fits most Parker County wells. See water well drilling cost in Weatherford or try the cost calculator.

Bottom line

Plan on about 240 ft for a typical Parker County household well, 300+ ft on the east side and in Hood County, and 200–220 ft in the north and west. The best estimate for a specific lot comes from the state reports for wells nearest it.

Questions about your own well? Call (817) 382-3840. A person answers 24/7.

Sources

  1. Texas Water Development Board, Submitted Drillers Reports (extract dated 2026-09-25)
  2. Upper Trinity GCD Groundwater Management Plan (2023), aquifer descriptions
  3. Upper Trinity GCD, District Rules (PDF posted September 2026), Rule 4.4(d), completion depth
  4. 16 Texas Administrative Code §76.100, surface completion standards

Planning a well or facing a repair? Call a well tech now.

Open 24 hours, 7 days a week. Serving Weatherford & Parker County.

Quick answers

How deep should a well be for drinking water in Texas?

Deep enough to reach a dependable water-bearing layer below surface influence, and completed with a proper surface seal. In Parker County that usually means 200–300 ft into Trinity sands, with the casing sealed at least 10 ft down under state rules. Depth alone doesn't make water safe. The seal and a bacteria test do.

Why are Aledo wells deeper than Peaster wells?

In the eastern part of the district, younger limestone layers cover the Trinity sands, so wells have to drill through that cap. Water also stands lower there: about 176 ft in new Aledo-area wells versus about 90 ft around Peaster.

Can I find the depth of my own well?

Yes, if a report was filed. Look for your State Well Report, or search the Texas Water Development Board's driller-report database by location. Reports have been filed online since 2001.

More residential well drilling guides

Residential Well Drilling service

Ask about your property

Share the address area and what you're planning. We'll call back with the nearby well depths and a price range.

Faster by phone, any hour: (817) 382-3840

We use your details only to call you back about this request. See our privacy notice.

(817) 382-3840 No water? A person answers 24/7